Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N109052
Screws for replacement pop out window frames. These screws are for joining the two Popout frame halves together
Application:The striker is what keeps the door closed, an absolute necessary part to say the least.
The striker is what keeps the door closed, an absolute necessary part to say the least. They are held in place by large screws. We suggest you use an impact drive to get the striker out. Note: Use masking tape to mark two sides of the old striker, so you will know where to set the new one. Before you completely tighten down the new striker, close the door and see how it lines up. If it lines up, tighten the screws. If it doesn't, start making adjustments until it does.
Ghia: 64-66
No customer reviews for the moment.
Part #: 211843792B
Seals the side sliding door on buses 1968 on.
Application:Part #: 131405670
This nut holds the front drum on.
Application:Part #: 113201075AB
These are new Brazilian tanks.
Application:Part #: 141955517A
This switch controls the wiper motor.
Application:Part #: 1501607
We make wheel adapters for some of the more common drums and wheels.
Application:Part #: 211863012
These are the interior panels.
Application:Part #: 111998161A
The wiper arms are connected to these shafts.
Application:Part #: 111101461
These nuts and washers hold the heads on.
Application:Part #: 113407361E
These joints are located in the ends of the control arms.
Application:Part #: 1198160B
These rings are cast iron.
Application:Part #: JC22270
Jaycee Billet Oil Cap with Breater -10 AN Fitting, Blue
Application:Part #: 113105281A
These shims set the endplay of the crankshaft.
Application:Part #: 1601132CH
Lug Nut, 12 point, 12mm-1.5, Chrome set of 5
Application:Part #: 1823566
This guard goes underneath the front hood handle to prevent your fingernails from scratching the paint..
Application:Part #: T1129028
Some carb combo's are tricky to sync, like kadrons that have a stud sticking up.
Application: