Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:This plate sits under the shifter to keep you from hitting reverse gear when you shift into 2nd.
This plate sits under the shifter to keep you from hitting reverse gear when you shift into 2nd. When installing the guide, the small ramp goes up and forward. If the lock out doesn't work, you should check your shift rod bushing. Used stop plates work fine as long as they are in good condition.
No customer reviews for the moment.
Part #: 261813164
This is what the battery sits on.
Application:Part #: N120141
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 2817022
This is a deluxe cover, not a cheap cover.
Application:Part #: 1117103ALF
# 8 Hose End 120 degree
Application:Part #: 2611905
Electric Vacuum Pump for Booster Brakes
Application:Part #: 1707135ABK
This is one of the original bumper options that was used on the first Cal-Look Bugs back in the 70's.
Application:Part #: 6881410
These seats are better than the fiberglass, but still no where near as good as beard seats.
Application:Part #: 141561410
Beautiful Classic Wood Thin Grip with Polished chrome Spokes
Application:Part #: 1198026A
This kit contains a quality urethane bushing, a clutch return spring and retaining clips needed to install the throw-out bearing arm in the transmission.
Application:Part #: 133053313
Trim Plate, Radio To Dash
Application:Part #: 111863002GY
Gray 4 pc Rubber Floor mat Set
Application:Part #: 111405692B
Front Bearing Grease Cap
Application:Part #: 111953560
Bearing Below Steering Wheel
Application:Part #: 111905865E
Ignition Switch, Euro
Application: