Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:If your stock bushings are worn out or you have an aluminum beam, we offer the following urethane bushings and replacements..
If your stock bushings are worn out or you have an aluminum beam, we offer the following urethane bushings and replacements.
Bug (Type 1): -65
Ghia: -65
Race/Off-Road: -65
No customer reviews for the moment.
Part #: 113117321
Hoover Bit, Oil Cooler Sealing Frame
Application:Part #: 186360311
These ride on the tunnel from the shifter forward.
Application:Part #: 1101448
This is a shim that is used between the head and barrel.
Application:Part #: T2501615
This is a great little tool for getting the rear axle nut off.
Application:Part #: 2847521A
This seal goes on the body of the bus, that the safari window closes against.
Application:Part #: 111251241A
This kit includes the gaskets and hardware to install a stock muffler or tail pipes..
Application:Part #: 111941351
These lights came stock on a 1967 Bug.
Application:Part #: 224845322AM
Center Window without Vent Wing Seal, American Style
Application:Part #: 112950506IDF
Throttle Shaft Nut for 40/44 HPMX (EMPI), 40-48 IDF (Weber)
Application:Part #: 113863705
This is a full carpet kit.
Application:Part #: 211405533
Kits contain the pins, bearings and shims which attach the spindle on king and link front ends to the axle beam.
Application:Part #: 1827152
These are a must if you live in an area were the temperature reaches 100 degrees or more.
Application:Part #: 070109345
These are the seals that go around the push rod tubes.
Application:Part #: 1109461
These shims are used under the rockers to set the geometry.
Application:Part #: 111857704BK
It's the law and a good idea to have seat belts.
Application:Part #: 133857180
These are the padded dashes that came on the 1968 and later Bugs.
Application: