Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These handles go on the inside of the front doors to open them. On bugs up to 1967 and on buses up to 1963 you will need to push back the small plastic bezel. You will see a pin coming in from the side. Use a small punch or a nail with the head removed to drive the pin out. We suggest you do this in a clean area because the pin usually flies out and you will want to be able to find it. Once the pin is out, wiggle the handle and it will come off. On 1968 and later cars, you will need to pry out the plastic cover inside the lever. Behind it you will need to remove the phillips screw. Then take the door panel off. There are two 10mm headed bolts that hold the latch on.
Bus (Type 2): 64-66
No customer reviews for the moment.
Part #: 181501263
These stub axles will convert your CV joints to Bus or 930 joints.
Application:Part #: 311405625BCH
These bearings go in the drum or rotor hub to allow them to spin. CHINA
Application:Part #: 0280150114
Fuel Injector T2
Application:Part #: 1251261
Paper gaskets are not our favorite, but if you are running larger ports, you have to use them.
Application:Part #: 113971935
Steering Coupler Ground Tab
Application:Part #: 1821305C
These were originally sold as an accessory by the dealer.
Application:Part #: 241863711E
This rubber mat goes on the front floor.
Application:Part #: 6501204
IRS Axles for Type 2 Transmissions with 930 CV Joints or 3x3 Arms, Sold as a Pair
Application:Part #: 311109335
These tubes go from the case to the heads to house the push rods.
Application:Part #: 211945241RK
This assembly comes with the bulb holder and lens.
Application:Part #: 1105277
Here are some flywheel pins that give you more contact surface on the flywheel.
Application:Part #: 151853535
These are the molding strips that go on top of the front doors and quarters.
Application:Part #: 113853601A
Front Hood Emblem
Application:Part #: 1129729
These boots can be put on without taking the intake manifold apart and should be used only in an emergency.
Application:Part #: n146841
Step stud
Application:Part #: 1615124B
Left Rear Caliper, 4x130, with Emergency Brake, Swing Axle
Application:
