Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
Rear Bumper, Primered
Rear Bumper, Primered
Bus (Type 2): 1973-79
No customer reviews for the moment.
Part #: 113707191C
This special chrome bolt has a round head on it.
Application:Part #: 211827905
This bracket holds the license plate to the car.
Application:Part #: 211801051HR
This area tends to rust.
Application:Part #: 1198162A
These rings are cast iron.
Application:Part #: 211837206
These are the front door handles.
Application:Part #: 1129702
EMPI EPC 34 or ICT Manifold kit for Dual Port Type 1 Engines
Application:Part #: 311837657A
These locks keep the vent wing closed, therefore a must, but they're a pain to replace.
Application:Part #: 151837633B
Vent wing Upper Pivot Screw, Convertible Bug (Type 1): 73-79
Application:Part #: 151857641CIV
Also known as the "oh shit" handle.
Application:Part #: 111953513F
This switch tells the flasher which way to send the current.
Application:Part #: N141341
These are the rear lenses for the tail light, brake light and turn signal light. Set of 4 Screws for 62-67 Bug taillight lens and 68-72 Bus front turn signal lens to body
Application:Part #: 1105297
This washer is larger in diameter than stock so it gives you more surface coverage over the dowel pins.
Application:Part #: 175947561
Door Contact Switch, fits either door
Application:Part #: T1601139
These assist studs are threaded on either end with both 12mm and 14mm to align and hold your stock wheels when you’re changing them.
Part #: 6863605
This is a console with two or three gauge holes (2 1/16").
Application:Part #: F1129601
These are the glues and oils we use..
Application:Part #: 2498211C
Do you have a lowered beam now? They should have come with a kidney belt and a mouth guard. These spindles will give you the stock ride and give you that lowered stance. They are sold on an exchange basis and come with new king pins. They do NOT come with link pins, so look at yours to see if you need new ones. Most of the time you do not need new ones...
Application:Part #: 6711177CL
A great shifter for sand cars.
Application:
Rear Bumper, Primered
