Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is the mechanism that makes the window go up and down.
This is the mechanism that makes the window go up and down. Getting the mechanism out is a pain. You will have to start by taking the door panel off and then disconnect the glass from the regulator. Now you're ready for the tough part. The vent wing post has to come loose so look for a bolt holding it to the inner skin of the door. Pay attention to how the regulator is installed in this area, as you will want to put it back the same way. Note: We lay the regulator down flat before installing, squirt some Triflow on the cable and then roll it up and down a few times. This will help the regulator last longer.
Bug (Type 1): 75-77
Off-Road: 75-77
No customer reviews for the moment.
Part #: 071251053C
This is the exhaust silencer.
Application:Part #: 151845521AAM
This seal is for the rear window. This is for a CONVERTIBLE ONLY.
Application:Part #: 151853535
These are the molding strips that go on top of the front doors and quarters.
Application:Part #: 1411298
Stainless Steel Clamps Only, Link pin/ Ball Joint
Application:Part #: 211707335D
Rear Bumper Bracket, Left
Application:Part #: 1711142BR
These knobs are made to fit all stock shifters and come with the shift pattern.
Application:Part #: 6511243
These grommets go on the spring plates in the torsion housing of your car.
Application:Part #: 1823566
This guard goes underneath the front hood handle to prevent your fingernails from scratching the paint..
Application:Part #: 113837019B
These handles go on the inside of the front doors to open them.
Application:Part #: 133415303
These two rods go from the center tie rod on a Bug, to the spindles, making the car turn.
Application:Part #: 113201215
This is a small rubber sleeve that goes on the neck of the gas tank before you slide the fuel filler hose on..
Application:Part #: 221817847
Air Distribution Knob, Silver Beige
Application:Part #: 111721305C
This is the shaft that the clutch pedal attaches to.
Application:Part #: 1105401CB
H-Beam Rods 5.500" Chevy Journal set of 4
Application:Part #: 211841600A
Cargo Door Mechanism Hardware, Includes hardware to mount both cargo door mechanisms
Application:Part #: 2129040
We've found that dual carbs work better than any single carburator set up.
Application:
This is the mechanism that makes the window go up and down.