Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is the mechanism that makes the window go up and down.
This is the mechanism that makes the window go up and down. Getting the mechanism out is a pain. You will have to start by taking the door panel off and then disconnect the glass from the regulator. Now you're ready for the tough part. The vent wing post has to come loose so look for a bolt holding it to the inner skin of the door. Pay attention to how the regulator is installed in this area, as you will want to put it back the same way. Note: We lay the regulator down flat before installing, squirt some Triflow on the cable and then roll it up and down a few times. This will help the regulator last longer.
Bug (Type 1): 55-64
Offroad: 55-64
No customer reviews for the moment.
Part #: 022109612A
The two outside valves in the head are the exhaust valves, they let the burned fuel out of the head.
Application:Part #: 1101482EMP
This is the replacement mounting hardware kit for Channel Gasket Style Valve Covers.
Application:Part #: 111885583
These are the parts needed to hold the back of the rear seat up.
Application:Part #: 113127303
The fuel pump sits on this little stand and it's also the guide for the push rod.
Application:Part #: 0231178009C
Empi Cast Steel Distributor Standard Curve Similar to Bosch 009
Application:Part #: 131415821A
These are the ball joints on the tie rods.
Application:Part #: T1141032
Clutch Alignment Tool
Application:Part #: 113867503
This is the vinyl covering for the inside roof and sides of the Bug.
Application:Part #: 211801326
Seat Pedestal Floor Repair Panel, Right
Application:Part #: 1615098A
Right Front Caliper, 5/205 for King and Link Pin Front end
Application:Part #: 1109415
These shims are used under the rockers to set the geometry.
Application:Part #: 1251159
Black Street Stinger with swivel flange
Application:Part #: 261809041D
Left Side Panel No Storage Compartment
Application:Part #: 1141026
We only offer brand new pressure plates because so-called rebuilt pressure plates never quite come up to factory pressure specs.
Application:Part #: 113415061C
If you have a lot of play in the steering don't just assume the steering box is bad.
Application:Part #: JC91000
Rebuild kit for Jaycee Leak proof Pushrod Tubes
Application:
This is the mechanism that makes the window go up and down.