Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This cable pulls the arm that releases the clutch.
This cable pulls the arm that releases the clutch. When replacing the cable, it will last longer and work better if you use white grease on it and on the clevis pin or hook. The easiest way to replace a cable is to remove the nut(s) from the clutch arm at the trans. Pull the bowden tube out of the bracket so it is straight. Pull the cable out from the front and replace it in the reverse order. On 68-71 Buses a two bolt bell where the clutch pedal shaft is bolted to the frame will need to be removed to get to the clevis pin. It is good idea to replace the clevis pin at this time on buses. We recommend having a spare in the car, in case it breaks while out in the middle of nowhere.
Type 3: -66
No customer reviews for the moment.
Part #: 211711630L
Heater cables open the flaps in the heater boxes allowing heat into the car.
Application:Part #: 211711331
Bus Parking Brake Cable Sleeve
Application:Part #: 315953161DCL
Bullet Clear Turn Signal Lens
Application:Part #: 151871045C
This boot keeps the wind from ripping up your top when it is down.
Application:Part #: 151845521DCL
This seal is for the rear window. This is for a CONVERTIBLE ONLY.
Application:Part #: 221883419
Middle Seat Floor Mount Reinforcement Plate, Welds onto floor and supplies support for mount
Application:Part #: 021105285
Endplay Shim .34mm
Application:Part #: 1129028
Replacement Tubes & Brackets only for Empi EPC 32/36F carbs
Application:Part #: 113837019BCH
Driver's Inside Door Handle
Application:Part #: 311698151B
These brake pads go into the calipers and are sold in sets of four; two per caliper.
Application:Part #: 111903221A
These are the bearings and brushes for your generator.
Application:Part #: N119761
Rear Seat Bar Screws, 6 required
Application:Part #: 211843406E
Lower Sliding Door Bracket
Application:Part #: N144111
Some of the most common studs you might need.
Application:Part #: 111721231B
Brake Pedal Stop Plate
Application:Part #: 211809101C
This is what everyone cut out in the 60's.
Application:
This cable pulls the arm that releases the clutch.
