Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
H4 Headlight bulb , 12 volts
H4 Headlight bulb , 12 volts
Bug (Type 1): For 1941001
Bus (Type 2): For 1941001
Type 3: For 1941001
Ghia: For 1941001
Thing: For 1941001
Offroad: For 1941001
No customer reviews for the moment.
Part #: 111827331A
Engine Deck Lid Spring
Application:Part #: 211857223
The radio block off plate covers the gaping hole if you do not have a radio or if you decide to locate it elsewhere..
Application:Part #: 211857545
These mirrors mount on the doors or door hinges so you can see what's behind you.
Application:Part #: F1129610
These are the glues and oils we use..
Application:Part #: 1611750B
These stainless steel braided flex lines don't swell like the original rubber hoses and they make the undercarriage look a lot nicer.
Application:Part #: 1127027
This regulator adjusts the fuel pressure to you carburator.
Application:Part #: 6881405
Race-Trim Low Mount Seat Mounts (Cannot use on Wide Seats)
Application:Part #: 6511243
These grommets go on the spring plates in the torsion housing of your car.
Application:Part #: N120141
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 111698131
This kit contains the replacement spring clips and rivets to hold hub caps on.
Application:Part #: 111105259
The bolt and washer that holds the crankshaft pulley on.
Application:Part #: 211501303
Reduction box, Rear Axle Bearing Spacer, 1 per side
Application:Part #: 1129033E
We have found this kit to be a good, cheap dual carb kit for a stock motor.
Application:Part #: 651300420
Suspension Limit Straps 20", Pair
Application:Part #: 2898061
Aluminum Side Steps
Application:Part #: 111837561
Door Window Lift Channel, Left
Application:
H4 Headlight bulb , 12 volts