Reduction Box Gaskets - Between box haves w/36mm nut

Part #: 211301265A

Transmission Mounts Stock - 10mm studs front

These rubber mounts hold the transmission in place.

• Bug (Type 1): 52-59
• Bus (Type 2): 63-67

Part #: 211301215

Nose Cones - Gasket

This is the front of the transmission that houses the shift lever.

• Bug (Type 1): 61-79
• Bus (Type 2): 59-67
• Type 3: 64-74
• Ghia: 61-74
• Thing: 73-74
• Race/Off-Road: 61-

Part #: 003301089D

Torque Converter Seal

Front Torque Converter Seal for Automatic Transmission

• Bus (Type 2): 73-79
• Type 3: 68-74

Part #: 211501303

Reduction box, Rear Axle Bearing Spacer, 1 per side

Reduction box, Rear Axle Bearing Spacer, 1 per side

• Bus (Type 2): 64-67

Part #: 211711169

Shift Rod Coupler, connects front to rear shift rods

Shift Rod Coupler, connects front to rear shift rods

• Bus (Type 2): 50-62 (Through chassis # 835087)

Part #: 091398005A

Transmission Gasket Sets

This kit contains all of the gaskets needed to rebuild a transmission.

• Bus (Type 2): 76-79

Part #: 6501141

Axle Tube Retainers - Swing axle

These retainers help stiffen the plates that bolts the tubes to the trans.

• Bug (Type 1): -68
• Bus (Type 2): -67
• Type 3: -68
• Ghia: -68
• Offroad/Race: -68

Part #: 211501273A

Reduction Box Gaskets - Between box haves w/46mm nut

This gasket goes between the reduction box halves.

• Bus (Type 2): 64-67

Part #: 211711171B

Rear Shift Rod, Connects Shift Rod to Transmission

Rear Shift Rod, Connects Shift Rod to Transmission

• Bus (Type 2): 62(From chassis # 835087) - 67

Part #: 002301189C

Final Drive Cap & Seal - Final drive seal inner

These are the seals that go around the final drives on an IRS transmission.

• Bus (Type 2): 68-79

Part #: 251711181

Shift Rod Support Pin for manual Transmissions only

Shift Rod Support Pin for manual Transmissions only

• Bus (Type 2): 80-83

Part #: 001301209A

Nose Cone Seal Holder

Nose Cone Seal Holder

• Bug (Type 1): 67-68
• Bus (Type 2): 67-68
• Ghia: 67-68
• Offroad/Race: 67-68

Part #: 2301150

Type 2 Transaxle Stabilizer (Mid-Mount)

This is a bolt on kit that reduces torsional stress felt at the front of the nose cone mount and rotational stress on the bell housing mounts.

Bus (Type 2); 56-67

Part #: 113311123A

Transmission Mainshaft Bearings - Standard

This is the main culprit of a noisy transmission.

• Bug (Type 1): 61-72
• Bus (Type 2): 59-67 
• Type 3: 64-72
• Ghia: 60-72
• Offroad: 61-

Part #: 001301207

Nose Cone Bushing, Rear, Late

Nose Cone Bushing, Rear, Late

• Bug (Type 1): 69-75
• Bus (Type 2): 69-75
• Ghia: 69-74
• Offroad/Race: 69-75

Part #: 001301209

Nose Cone Bushing, Front, Late

Nose Cone Bushing, Front, Late

• Bug (Type 1): 69-79
• Bus (Type 2): 69-75
• Ghia: 69-74
• Offroad/Race: 69-79