Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
Throttle Cable Extender for Morse and EMPI cables (10-32 thread) 8" cut to length
Throttle Cable Extender for Morse and EMPI cables (10-32 thread) 8" cut to length
Offroad/Race: All
No customer reviews for the moment.
Part #: 211501317
This seal keeps the grease in the bearings on IRS busses.
Application:Part #: 2251002
We like to run EMPI deluxe headers because they have the best fit, as well as, a good merge on the collector.
Application:Part #: 021198031
These gaskets are used on the sump plates of the engine.
Application:Part #: 039101061D
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 071251053C
This is the exhaust silencer.
Application:Part #: 211837502
This is the mechanism that makes the window go up and down.
Application:Part #: 1881213
We really like the style and comfort that these seats provide.
Application:Part #: 113711141GY
This is the knob on top of the shifter..
Application:Part #: 113847079C
Pop Out Window Latch, Left
Application:Part #: N122769
Striker Plate Screws, Set of 8
Application:Part #: 021251235
This kit includes the gaskets and hardware to install a stock muffler or tail pipes..
Application:Part #: 1109310
These lifters are made by Engle and have a small hole in the end of them that allows oil to be pumped onto the cam lobe and lifter face.
Application:Part #: 1517289
These seals fit into the CV joint flange to keep the axle from beating the transmission cup and to keep the transmission oil out of the CV joint.
Application:Part #: 11310140102
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 311943131
This is the lens and seal for the light that shines on the license plate.
Application:Part #: 6857638
Weld on Dash Grab Handle.
Application:
Throttle Cable Extender for Morse and EMPI cables (10-32 thread) 8" cut to length
