Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N141212
These are the latches that hold the popout frame out.
Application:These snubbers last a lot longer than stock snubbers.
These snubbers last a lot longer than stock snubbers. To install them, you will have to get the upper arm off the snubber. If the old snubber is there, cut it off. Put some oil in the hole of the new snubber and drive it on. If that doesn't work, boil some water and set the snubber in it. This will soften up the urethane and make it easier to put on.
Bug (Type 1): -65
Bus (Type 2): -62
Ghia: -65
Race/Off-Road: -65
No customer reviews for the moment.
Part #: 6251001
These systems work well with a single carb set up as they have provisions for the heat riser.
Application:Part #: 021101403A
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 113201075AD
These are new Brazilian tanks.
Application:Part #: 1405075
Replacement Brake Rotor Double Drilled 5x130mm and 5x4.75"
Application:Part #: 1101392
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 211405671
Spindle Nut, 32mm, M22x1.5LH
Application:Part #: 211599431
Transmission mount
Application:Part #: 002141701A
This shaft holds the throw-out bearing in place.
Application:Part #: 113251265
This kit includes the gaskets and hardware to install a stock muffler or tail pipes..
Application:Part #: 6905821
Sealed Momentary Push Button Starter Switch
Application:Part #: 131415821A
These are the ball joints on the tie rods.
Application:Part #: 113129034KIT
This adapter is used when you want to put a 30PICT carb on a dual port manifold. Will only work with a round bowl style carb. It will NOT work with a square bowl carb.
Application:Part #: 211301265A
These rubber mounts hold the transmission in place.
Application:Part #: 111801172C
The heater channel carries heat form the heater boxes to the front of the car.
Application:Part #: 211501357
Torque plate
Application:Part #: 6881410ABL
These seats are better than the fiberglass, but still no where near as good as beard seats.
Application: