Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N109052
Screws for replacement pop out window frames. These screws are for joining the two Popout frame halves together
Application:
This will replace a worn out pivot for the stock accelerator assembly, to replace this pivot you will have to remove the whole pedal assembly.Make sure you use some white grease on the pin where it mounts to the pedal to insure that it lasts longer..
This will replace a worn out pivot for the stock accelerator assembly, to replace this pivot you will have to remove the whole pedal assembly.Make sure you use some white grease on the pin where it mounts to the pedal to insure that it lasts longer.
Bug (Type 1): 58-65
Type 3: 64-65
Ghia: 58-65
Race/Off-Road: 58-65
No customer reviews for the moment.
Part #: 211798002B
Front Bumper Bolt Kit
Application:Bus (Type 2); 73-79
Part #: 141881405
Like the door panels, seat covers are a long subject; so here's the basics.
Application:Part #: 211831721DBR
Front door seals keep out the wind, rain, dirt and noise.
Application:Part #: 1847101RASY
Hinge Assembly Bug Safari Right
Application:Part #: 211259371A
Fresh Air Lever, Red
Application:Part #: 211953162B
These are the lenses that go over the front turn signal bulb holders.
Application:Part #: 1601028BCP
EMPI 8 Spoke Replacement Black Center Cap
Application:Part #: 6251008
Systems are designed for max horsepower and to handle the punishment of off-road competition.
Application:Part #: 2711099PL
Gear shift extensions angle back and add about 5" of length to your stock shifter, which allows you to reach the shifter without leaning forward..
Application:Part #: 043298001
This kit includes the gaskets and hardware to install a stock muffler or tail pipes..
Application:Part #: 1129033E
We have found this kit to be a good, cheap dual carb kit for a stock motor.
Application:Part #: 1863620W
This basket fits perfectly on your carpeted console area. This is for those of you who FINALLY wanted a cup holder and/or a goodie basket. I
Application:Part #: 1109451
This style of adjusting screw has a ball with a flat side on the end.
Application:Part #: 6129650476BK
Outerwear pre-filters feature a patented; Micro Mesh nylon filtration system that stops sand and dirt before it gets to your air cleaner element.
Application:Part #: 111127591A
Fuel Line Grommet 8mm
Application:Part #: 1129025
This is a new aftermarket UNIVERSAL intake manifold for Dual Port Engines. You can use a 30 Pict1 or 34Pict3 Carburetor. We have had major icing problems with this part and prefer stock manifolds.
Application:
This will replace a worn out pivot for the stock accelerator assembly, to replace this pivot you will have to remove the whole pedal assembly.Make sure you use some white grease on the pin where it mounts to the pedal to insure that it lasts longer..
