Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These fittings are used for the stainless steel hose.
These fittings are used for the stainless steel hose. Keep in mind there will be two fittings per connection. On the pipe thread end use teflon tape and don't "muscle" them. Turn them as tight as you can by hand, then one more full turn with a wrench.
Bug (Type 1): All
Bus (Type 2): All
Type 3: All
Ghia: All
Thing: All
Race/Off-Road: All
No customer reviews for the moment.
Part #: JC22660
Jaycee Street Oil Filter Bracket, Black
Application:Part #: 311115541
This boot goes on the end of the dump tube.
Application:Part #: 1117106
When plumbing the oil filter, oil cooler and/or case, these are the fittings you will need.
Application:Part #: 111115487
It caps the hole you are aiming at while pouring oil over everything else.
Application:Part #: 1115421
These stronger springs were designed to boost the oil pressure in your motor.
Application:Part #: 1117108ALF
These fittings are used for the stainless steel hose.
Application:Part #: 113117021
This stock oil cooler cools the hot oil coming from the engine.
Application:Part #: 1115452
This stock oil filler and cap has been chromed.
Application:Part #: 1117101
When plumbing the oil filter, oil cooler and/or case, these are the fittings you will need.
Application:Part #: 113115193
This is the bolt that goes in the plate on the bottom of the motor.
Application:Part #: 1115467
This is a breather box that will give excess "blow by" a place to go.
Application:Part #: 6115349
If you built your motor out of a type 3 case, you probably notice that once you got it all together you're missing a dipstick tube.
Application:Part #: N110623
Some of the more common nuts you might need..
Application:Part #: 1115183
This plate is made out of a solid piece of aluminum.
Application:Part #: 021117151A
This stock oil cooler cools the hot oil coming from the engine.
Application:Part #: 111115475A
Oil Filler Seal, 25-36 HP
Application:
These fittings are used for the stainless steel hose.
