Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This cap sits on the top of the brake fluid reservoir filler hole.
This cap sits on the top of the brake fluid reservoir filler hole. If you have the OE reservoir up to 1960, it takes a rubber plug. If you have a new reservoir, then it takes the screw on cap. If you over tighten the cap, it will split.
No customer reviews for the moment.
Part #: 211255725E
Heater Tube Insulating Cover, Rear Fork
Application:Part #: 1129510
We've found that dual carbs work better than any single carburator set up.
Application:Part #: 113609001
Backing Plate Bolt Kit
Application:Part #: 04138
These are the parts found in the distributor.
Application:Part #: ECX95
ECP part numbers are for the regular crimp style electrical ends.
Application:Part #: 6798074
SS Roller Pedal Cable Bracket
Application:Part #: 211711169A
This coupler attaches the shift rod to the transmission.
Application:Part #: N144031
Some of the most common studs you might need.
Application:Part #: 111105223
This brass gear goes on the crank to turn the distributor drive shaft.
Application:Part #: 068251053D
This is the exhaust silencer.
Application:Part #: 111101123
These pins position the main bearings in the case halves so you can line up the oil galley holes with the main bearings.
Application:Part #: 135945191
This seal goes between the tail light housing and the body of the car..
Application:Part #: 1127100
Hose Clamp for 5mm hose
Application:Part #: 1511221
Torsion Tube End Plates, Inner, Pair
Application:Part #: 143845521CCL
This seal is for the rear window.
Application:Part #: N124351
Door Mechanism Clip, Bus Check Rod Pin Clip, Bus Engine Lid Support Roller Mounting Clip
Application:
This cap sits on the top of the brake fluid reservoir filler hole.