Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is the front of the transmission that houses the shift lever.
This is the front of the transmission that houses the shift lever. Used ones are fine as long as the bushings are good and they're not cracked. Note: Use a new gasket with Gasgacinch for a sealer. Don't over tighten the 11mm nuts. For those of you who are putting a syncro style trans into a 53-59 Bug, you'll need the Bus nose cone and front mount. Those of you with a 60 Bug, punt.
Bug (Type 1): 61-79
Bus (Type 2): 59-67
Type 3: 64-74
Ghia: 61-74
Thing: 73-74
Race/Off-Road: 61-
No customer reviews for the moment.
Part #: 1301263
These mounts made of urethane never wear-out.
Application:Part #: 1301265
These mounts made of urethane never wear-out.
Application:Part #: 6501141
These retainers help stiffen the plates that bolts the tubes to the trans.
Application:Part #: 1301049
These straps are a good idea if you have a car with a big engine.The rear strap keeps the bell housing from twisting and the front strap keeps the nose of the transmission from breaking the front mount.We highly recomend that you use these in conjunction with the urethane transmission mounts.
Application:Part #: 211301205H
This is the front of the transmission that houses the shift lever.
Application:Part #: 1301150
Bolt on Center Transmission mount, Urethane stops included
Application:Part #: 311301265A
These rubber mounts hold the transmission in place.
Application:Part #: 111501131
This kit contains all of the gaskets needed to rebuild a transmission.
Application:Part #: 001301083
This seal keeps the fluid in the converter.
Application:Part #: 311301343
Sleeve
Application:Part #: 111301155
This is the bushing between the bellhousing of the transmission and the starter.
Application:Part #: 311301265B
These rubber mounts hold the transmission in place.
Application:Part #: 111301207
Nose Cone Bushing, Front or Rear, Early
Application:Part #: 311301265BFA
Transmission mount, Front
Application:Part #: 113301189F
These are the seals that go around the final drives on an IRS transmission.
Application:Part #: 1301266
Trans Axle Adapter Kit
Application:
This is the front of the transmission that houses the shift lever.