Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N109052
Screws for replacement pop out window frames. These screws are for joining the two Popout frame halves together
Application:We like to run EMPI deluxe headers because they have the best fit, as well as, a good merge on the collector.
We like to run EMPI deluxe headers because they have the best fit, as well as, a good merge on the collector. The collector is the most important part of a header. We suggest using a single quiet muffler on engines that have a stock carburetor or two, one-barrel carbs. You should run dual mufflers or one giant muffler on engines that have two, two-barrel carbs. If you're using the stock intake manifold, you'll need to drill out the heat riser stands on the header.
Bug (Type 1): 1300-1600
No customer reviews for the moment.
Part #: 1251201
When you upgrade to dual carburetors, use these plates to block off the heat risers on your headers or stock exhaust system.
Application:Part #: 111251241A
This kit includes the gaskets and hardware to install a stock muffler or tail pipes..
Application:Part #: 1251009
We like to run EMPI deluxe headers because they have the best fit, as well as, a good merge on the collector.
Application:Part #: 1251005
We like to run EMPI deluxe headers because they have the best fit, as well as, a good merge on the collector.
Application:Part #: 1251166
This is a reproduction of an accesory that was offered by the dealer.
Application:Part #: 1251008H
1 5/8" Merged Flanged Header with Stinger (No Heater Boxes Included)
Application:Part #: 1251005LF
Large 3 bolt flange Single Quiet pack Muffler
Application:Part #: 1251159
Black Street Stinger with swivel flange
Application:Part #: 1256092
Also called J-tubes, these tubes fit most header systems and replace the stock heater boxes, so you will lose your heat and defroster..
Application:Part #: 1251163
These fit all stock mufflers and come in three different styles..
Application:Part #: 1251004
We like to run EMPI deluxe headers because they have the best fit, as well as, a good merge on the collector.
Application:Part #: 1251161
A stinger (depending on your motor combo) makes horsepower at 5K RPM and above.
Application:Part #: 1251167
These fit all stock mufflers and come in three different styles..
Application:Part #: 125121112
Exhaust nuts 12 Point 8mm-1.25, use 10mm 12 point socket (8 per kit)
Application:Part #: 1251014C
We like to run EMPI deluxe headers because they have the best fit, as well as, a good merge on the collector.
Application:Part #: 1251201CH
Chrome Heat Riser Block-Off Plate Kit
Application: