Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is what delivers gas and air to the engine.
This is what delivers gas and air to the engine. It would take a book to explain all of the symptoms of a bad carburetor. A simple check is to use a mirror and a flashlight to see if fuel is dripping onto the butterfly while the engine is idling. If it's dripping then there is a good chance it's bad. Another check is with the motor off, grab the throttle arm down where the butterfly shaft is and see if it moves back and forth. Again if it moves, the shaft is worn out and you should think about replacing it.
No customer reviews for the moment.
Part #: 1129506PRO
Velocity Stack Covers, for 48IDA/EPC 48 & EPC 51 Carbs, Pair Inside Diameter is 3.850"
Application:Part #: 1129505002
These are some of the most common jets used.
Application:Part #: 1129515PR
Linkage Down Rod Extensions, Short & Long, Pair
Application:Part #: 112950502IDF
Mixture Screw Spring for 40/44 HPMX (EMPI), 40-48 IDF (Weber)
Application:Part #: 1129510A
We've found that dual carbs work better than any single carburator set up.
Application:Part #: 113129034KIT
This adapter is used when you want to put a 30PICT carb on a dual port manifold. Will only work with a round bowl style carb. It will NOT work with a square bowl carb.
Application:Part #: 1129506IDF
Velocity Stack Covers, for IDF & HPMX Carbs, Pair Fits carbs with velocity stacks & no air cleaners
Application:Part #: 1129039E
Empi Dual 40mm Carburetor complete setup
Application:Part #: 111129493A
Steel Vacuum Line junction between Vacuum Advance and carburetor
Application:Part #: 112950507IDA
Main Jet Screen
Application:Part #: 1129034
We have found this kit to be a good, cheap dual carb kit for a stock motor.
Application:Part #: 111198569A
This kit comes with the gaskets, the needle and seat, and accelerator pump diaphragm for the carburetor..
Application:Part #: 1129027
This raises a stock 28/30PICT carburetor to clear the 12 volt alternator or generator..
Application:Part #: 113129031K
This is what delivers gas and air to the engine.
Application:Part #: 1129139
This is a good, cheap dual carburetor kit for a 1600cc motor.
Application:Part #: N137761
Here are some of the replacement parts for your stock carburetor..
Application:
This is what delivers gas and air to the engine.