Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
We have found this kit to be a good, cheap dual carb kit for a stock motor.
We have found this kit to be a good, cheap dual carb kit for a stock motor. Throttle bushings wearing out over time is the only bad thing we can say about them. We suggest you change the fuel hose in the kit to German hose. *Part numbers ending in an E are reproductions of Weber Carb Kits by Empi.
Bug (Type 1): 1500-1600
Bus (Type 2): 1500-1600
Ghia: 1500-1600
Off-Road: 1500-1600
No customer reviews for the moment.
Part #: 1129505016
These are some of the most common jets used.
Application:Part #: 113129323C
Here are some of the replacement parts for your stock carburetor.
Application:Part #: 1129028
Replacement Tubes & Brackets only for Empi EPC 32/36F carbs
Application:Part #: 112950505IDA
Stack Hold Down Tab
Application:Part #: 1129199050
Accelerator Pump Jets for 40/44 HPMX (EMPI), 40-48 IDF (Weber) 0.50
Application:Part #: 113129027EMP
This is what delivers gas and air to the engine.
Application:Part #: 1129034E
We have found this kit to be a good, cheap dual carb kit for a stock motor.
Application:Part #: 1198578
This kit has the gaskets, o-rings, accelerator pump and needle and seat to rebuild an IDF carb.
Application:Part #: 113129391
Here are some of the replacement parts for your stock carburetor..
Application:Part #: 112950506IDF
Throttle Shaft Nut for 40/44 HPMX (EMPI), 40-48 IDF (Weber)
Application:Part #: 1129040E
We've found that dual carbs work better than any single carburator set up.
Application:Part #: 1129304040
These are some of the most common jets used. Sold individually.
Application:Part #: 1129139
This is a good, cheap dual carburetor kit for a 1600cc motor.
Application:Part #: 1129199055
Accelerator Pump Jets for 40/44 HPMX (EMPI), 40-48 IDF (Weber) 0.55
Application:Part #: 1129506PRO
Velocity Stack Covers, for 48IDA/EPC 48 & EPC 51 Carbs, Pair Inside Diameter is 3.850"
Application:Part #: 1129404150
These are some of the most common jets used. Sold individually. .150
Application:
We have found this kit to be a good, cheap dual carb kit for a stock motor.
