Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N109052
Screws for replacement pop out window frames. These screws are for joining the two Popout frame halves together
Application:This is a good, cheap dual carburetor kit for a 1600cc motor.
This is a good, cheap dual carburetor kit for a 1600cc motor. What we don't like is the throttle bushings wear out over time and you need to change the fuel hose it comes with to a German hose. If you need different jet see carburetor parts. They take stock solex idle jets and main jets.
Bug (Type 1): 1600
Bus (Type 2): 1600
Ghia: 1600
Thing: 1600
Off-Road: 1600
No customer reviews for the moment.
Part #: 1129511
This is a good, cheap dual carburetor kit for a 1600cc motor.
Application:Part #: 1129199050
Accelerator Pump Jets for 40/44 HPMX (EMPI), 40-48 IDF (Weber) 0.50
Application:Part #: 113198575URP
This kit comes with the gaskets, the needle and seat, and accelerator pump diaphragm for the carburetor..
Application:Part #: 113129415B
Here are some of the replacement parts for your stock carburetor. Sold individually. No. 70
Application:Part #: 1129310
Empi Idle Jet Vent Tube Kit
Application:Part #: 111129405C
Here are some of the replacement parts for your stock carburetor..
Application:Part #: 1129510A
We've found that dual carbs work better than any single carburator set up.
Application:Part #: 1129504115
These are some of the most common jets used. Sold individually.
Application:Part #: 1129512
Empi Hex Bar Linkage for 48/51 EPC and 48 IDA (works with and without Air Cleaners)
Application:Part #: 1129516
Empi Hex Bar Linkage Bearing Conversion Kit
Application:Part #: 1129201300
EPC 48/51 3.0 Needle and Seat IDA 300
Application:Part #: 112950503IDA
Fast Idle Screw and Spring
Application:Part #: 1129306075
These are some of the most common jets used.
Application:Part #: 113129027HBR
Carburetor 30 Pict 1300-1600
Application:Part #: 1198578
This kit has the gaskets, o-rings, accelerator pump and needle and seat to rebuild an IDF carb.
Application:Part #: 1129511B
Kadron Carburetor Linkage Ball Socket Ends, 10/32 Left & Right, Pair
Application: