Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:We have found this kit to be a good, cheap dual carb kit for a stock motor.
We have found this kit to be a good, cheap dual carb kit for a stock motor. Throttle bushings wearing out over time is the only bad thing we can say about them. We suggest you change the fuel hose in the kit to German hose. *Part numbers ending in an E are reproductions of Weber Carb Kits by Empi.
Type 3: 1600
No customer reviews for the moment.
Part #: 112950506IDF
Throttle Shaft Nut for 40/44 HPMX (EMPI), 40-48 IDF (Weber)
Application:Part #: 1129505007
These are some of the most common jets used.
Application:Part #: 341129795
Carburetor Base Gasket
Application:Part #: 1129324
These are some of the most common jets used.
Application:Part #: 11295076IDF
6" Chrome Velocity Stacks, Pair
Application:Part #: 1129505115
These are some of the most common jets used. Sold in Pairs
Application:Part #: 1129512
Empi Hex Bar Linkage for 48/51 EPC and 48 IDA (works with and without Air Cleaners)
Application:Part #: 3129034E
We have found this kit to be a good, cheap dual carb kit for a stock motor.
Application:Part #: 112950501IDF
Mixture Screw for 40/44 HPMX (EMPI), 40-48 IDF (Weber)
Application:Part #: 1129201300
EPC 48/51 3.0 Needle and Seat IDA 300
Application:Part #: 1129310
Empi Idle Jet Vent Tube Kit
Application:Part #: 1129508
These are some of the most common jets used.
Application:Part #: 112950502IDF
Mixture Screw Spring for 40/44 HPMX (EMPI), 40-48 IDF (Weber)
Application:Part #: 1129802
We've found that dual carbs work better than any single carburator set up.
Application:Part #: 1129199050
Accelerator Pump Jets for 40/44 HPMX (EMPI), 40-48 IDF (Weber) 0.50
Application:Part #: 1129516
Empi Hex Bar Linkage Bearing Conversion Kit
Application: