Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
We have found this kit to be a good, cheap dual carb kit for a stock motor.
We have found this kit to be a good, cheap dual carb kit for a stock motor. Throttle bushings wearing out over time is the only bad thing we can say about them. We suggest you change the fuel hose in the kit to German hose. *Part numbers ending in an E are reproductions of Weber Carb Kits by Empi.
Bus (Type 2): 1700-2000
No customer reviews for the moment.
Part #: 1129804
This is a good, cheap dual carburetor kit for a 1600cc motor.
Application:Part #: 113129191G
Here are some of the replacement parts for your stock carburetor..
Application:Part #: 1129505002
These are some of the most common jets used.
Application:Part #: 1129404150
These are some of the most common jets used. Sold individually. .150
Application:Part #: 1129310
Empi Idle Jet Vent Tube Kit
Application:Part #: 049129412C
Here are some of the replacement parts for your stock carburetor..
Application:Part #: 112950508IDA
Auxiliary Venturi
Application:Part #: 1129508
These are some of the most common jets used.
Application:Part #: 112950506IDF
Throttle Shaft Nut for 40/44 HPMX (EMPI), 40-48 IDF (Weber)
Application:Part #: 1129039E
Empi Dual 40mm Carburetor complete setup
Application:Part #: 113129881A
Here are some of the replacement parts for your stock carburetor..
Application:Part #: 113129031K
This is what delivers gas and air to the engine.
Application:Part #: 2129040
We've found that dual carbs work better than any single carburator set up.
Application:Part #: 1129506PRO
Velocity Stack Covers, for 48IDA/EPC 48 & EPC 51 Carbs, Pair Inside Diameter is 3.850"
Application:Part #: 2129510
We've found that dual carbs work better than any single carburator set up.
Application:Part #: 1129201300
EPC 48/51 3.0 Needle and Seat IDA 300
Application:
We have found this kit to be a good, cheap dual carb kit for a stock motor.
