Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N109052
Screws for replacement pop out window frames. These screws are for joining the two Popout frame halves together
Application:We have found this kit to be a good, cheap dual carb kit for a stock motor.
We have found this kit to be a good, cheap dual carb kit for a stock motor. Throttle bushings wearing out over time is the only bad thing we can say about them. We suggest you change the fuel hose in the kit to German hose. *Part numbers ending in an E are reproductions of Weber Carb Kits by Empi.
Bug (Type 1): 1500-1600
Bus (Type 2): 1500-1600
Ghia: 1500-1600
Off-Road: 1500-1600
No customer reviews for the moment.
Part #: 1129506IDA
Velocity Stack Covers, for 48IDA/EPC 48 & EPC 51 Carbs, Pair
Application:Part #: 111198569A
This kit comes with the gaskets, the needle and seat, and accelerator pump diaphragm for the carburetor..
Application:Part #: 1129201300
EPC 48/51 3.0 Needle and Seat IDA 300
Application:Part #: 1129505008
These are some of the most common jets used.
Application:Part #: 112950503IDA
Fast Idle Screw and Spring
Application:Part #: 112950504IDF
Idle Jet O-ring for 40/44 HPMX (EMPI), 40-48 IDF (Weber)
Application:Part #: 1129199055
Accelerator Pump Jets for 40/44 HPMX (EMPI), 40-48 IDF (Weber) 0.55
Application:Part #: 1129139
This is a good, cheap dual carburetor kit for a 1600cc motor.
Application:Part #: 1129044
We've found that dual carbs work better than any single carburator set up.
Application:Part #: 1129026
34 Pict Carburetor spacer plate, measures 3/8" thick with 2 11/16" hole to hole
Application:Part #: 111129405C
Here are some of the replacement parts for your stock carburetor..
Application:Part #: 1129199050
Accelerator Pump Jets for 40/44 HPMX (EMPI), 40-48 IDF (Weber) 0.50
Application:Part #: 113129881A
Here are some of the replacement parts for your stock carburetor..
Application:Part #: 112950503IDF
Cupwasher for Idle Jet O-ring for 40/44 HPMX (EMPI), 40-48 IDF (Weber)
Application:Part #: 1129034E
We have found this kit to be a good, cheap dual carb kit for a stock motor.
Application:Part #: 113129323B
Here are some of the replacement parts for your stock carburetor.
Application: