Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is the pulley on the generator that holds the belt.
This is the pulley on the generator that holds the belt. When replacing the pulley, make sure you have a total of eight shims. Place the pulley half, with the key way in it, on the generator. Install three shims, the belt and the other pulley half. Now place the other five shims on the generator, then the bell and the nut. Tighten the nut, letting the belt slip and the engine turn. Once the belt has ridden all the way up, use a screwdriver in the slot and tighten the nut. Check the tension of the belt. If it's too loose, take out a shim in the middle and add it to the outside. If it's too tight, add one from the outside to the middle. Note: If you run the belt too tight, you will ruin the bearings in the generator. It is imperative you have a total of eight shims, otherwise you will be throwing pulleys and buying a new generator.
No customer reviews for the moment.
Part #: GR15NC
Generators supply the battery with voltage.
Application:Part #: 211903183
This is the bell shaped spacer that hold the outer half of the generator pulley on.
Application:Part #: 042903109ABR
This is the pulley on the generator that holds the belt.
Application:Part #: 1301103
This bushing is made to mate mismatched bellhousing and starter combinations.
Application:Part #: GR11XCO
Generators supply the battery with voltage.
Application:Part #: 111119131
Fan Hub Washer
Application:Part #: GR15X
Generators supply the battery with voltage. Rebuilt + Core
Application:Part #: 1903183
This aftermarket chrome cap nut and spacer hold the alternator/generator pulley on.
Application:Part #: GR15XCO
Core Charge Generators supply the battery with voltage. Rebuilt
Application:Part #: SR15HT
This is what starts the car.
Application:Part #: 1903137
Replacement belt for Serpentine belt driven Alternator or Generator
Application:Bug (Type 1); 40-1600
Bus (Type 2); 40-1600
KG; 40-1600
Thing; All
Offroad; 40-1600
Part #: 1903109SHIM
Billet Alternator/Generator Pulley Shim Kit (Pack of 5)
Application:Part #: 113903141A
The generator strap goes around the generator and holds the generator to the stand..
Application:Part #: 1903532
This is just a cover that fits around a 30amp generator to give it that chrome look.
Application:Part #: 1903109BOPO
Billet Pulley Outer Half Polished
Application:Part #: 113119031A
This is the fan that fits inside of the fan shroud on Bugs 1971-1979 and a 1971 Bus.
Application:
This is the pulley on the generator that holds the belt.
