Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
Generators supply the battery with voltage.
Generators supply the battery with voltage. To test a 12v generator, take the wires off the D+ and the DF terminals. Grab a volt meter and hook up the volt meter so the positive lead goes to the D+ and the negative to the DF. Now run a jumper wire from the DF to the D-. Start the car and rev the motor. If the meter pegs, the generator is good and if it doesn't, then it's bad. Now if the meter jumps to lower voltage the generator may need to be polorized. To polorize a generator, make sure the voltage regulator wires are still disconnected. Take off the generator belt. Using a battery with jumper cables, hook up the positive to the D+ and the negative to D-. Now with a jumper wire, go from the DF to the body of the generator. Hold the wire there just long enough to see the generator spin like a motor; no longer, or you will burn up the generator. Some generators are sold on exchange.
Bug (Type 1): -66
Bus (Type 2): -64
Ghia: -66
Race/Off-Road: -66
No customer reviews for the moment.
Part #: 1301104
This bushing is made to mate mismatched bellhousing and starter combinations.
Application:Part #: 111903137E
This is the belt that turns the generator.
Application:Part #: JC86000
Jaycee Billet Alternator Pulley, Blue
Application:Part #: 211903183
This is the bell shaped spacer that hold the outer half of the generator pulley on.
Application:Part #: 1903109CH
This is a stock generator pulley that has been chromed.
Application:Part #: SR17XCO
This is what starts the car.
Application:Part #: GR15X
Generators supply the battery with voltage. Rebuilt + Core
Application:Part #: 111903221A
These are the bearings and brushes for your generator.
Application:Part #: 1903109BOPO
Billet Pulley Outer Half Polished
Application:Part #: 111119141A
Cooling Fan Nut
Application:Part #: 1903109BOBL
Billet Pulley Outer Half Blue
Application:Part #: 113119031A
This is the fan that fits inside of the fan shroud on Bugs 1971-1979 and a 1971 Bus.
Application:Part #: 1903141
This chrome strap holds the alternator or generator to the stand.
Application:Part #: SR17X
This is what starts the car.
Application:Part #: 042903109ABR
This is the pulley on the generator that holds the belt.
Application:Part #: 1903141B
This strap is much stronger than the stock strap, not that you need a super strap to hold the alternator or generator.
Application:
Generators supply the battery with voltage.
