Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These are the metal brake lines found throughout the car.
These are the metal brake lines found throughout the car. We suggest you go buy a 11mm tubing wrench and a tubing bender before you start replacing lines. If you have an extra 11mm box end wrench, you can cut a slot in the box end which will allow you to slip it over the tube. When breaking the metal line loose from the brake hose, use a 17mm wrench on the hose and the 11mm wrench on the metal line. Once you have broken it free, remove the clip that holds the hose. When installing the new line, hand thread the nut into the brake hose and then install the clip and tighten. You will need to take out the driver's seat when replacing the front to rear line because it runs along the tunnel. Cut the old line in half. Unthread both ends, one at the master cylinder and the one at the rear union. Pull it out from the inside of the car. Now make the bends in the new line with the tubing bender using the old line as a pattern. Install the new line from the inside of the car starting with the front. Make sure you have grommets where the line goes through the firewalls.
Bug (Type 1): 69-
Ghia: 69-
Thing: 73-74
Race/Off-Road: 69-
No customer reviews for the moment.
Part #: 211837605
Vent Window Assembly, Left
Application:Part #: 151801131B
These are the replacement rails for convertibles.
Application:Part #: 111698700
Steel Brake Line Kit (7 Pieces)
Application:Part #: 6721356D
Slave Cylinder Trans Bracket Billet for Mendeola Transmissions
Application:Part #: 113853555C
These are the correct trim moldings for your running boards.
Application:Part #: 251405645B
These bearings go in the drum or rotor hub to allow them to spin.
Application:Part #: N0143893
These are some of the most common clips you will need when putting your car back together.. Approximately 60 needed for both front doors and rear panels
Application:Bug (Type 1): 54-77
Ghia: 56-74
Type 3: 64-74
Part #: 211829193E
It seals the rear cargo door and has to be glued in.
Application:Part #: 211971017
The electrical harness runs everything on the car.
Application:Part #: 211611070C
This hydraulic slave cylinder is found in the front brake backing plate.
Application:Part #: 1903109SHIM
Billet Alternator/Generator Pulley Shim Kit (Pack of 5)
Application:Part #: 113805591A
This is the front skin on the Bug.
Application:Part #: 1601028BLT
EMPI 8 Spoke Replacement Hardware for Center Cap
Application:Part #: 111201261
Fuel Breather Hose Clip
Application:Part #: 211837375B
Front Door Felt Channel Kit (No Notch)
Application:
These are the metal brake lines found throughout the car.
