Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These locks keep the vent wing closed, therefore a must, but they're a pain to replace.
These locks keep the vent wing closed, therefore a must, but they're a pain to replace. Start by removing the glass and rubber. Use a 1/8" drill and drill out the original rivets. Next, remove whatever is left of the old lock and install the new lock. Using 1/8" pop rivets, install the head of the lock from the frame side. With a hammer and dolly, very carefully flatten what's left of the rivet on the latch side. Now replace the glass and rubber.
Bug (Type 1): 65-67
Type 3: 62-67
Race/Off-Road: 65-67
No customer reviews for the moment.
Part #: 6601202
Aluminum Hub 5x205 for Combo Spindles
Application:Part #: 111821707BRR
This is the beading that goes between the fender and the body.
Application:Part #: 1129627
CB 650 Dual Valve Springs (Set)
Application:Part #: 070251235
This kit includes the gaskets and hardware to install a stock muffler or tail pipes..
Application:Part #: 251407641A
These are the inner bearing seals on the drums or rotors.
Application:Part #: 111831421
These pins are in the door hinges.
Application:Part #: N119511
Sunroof Cover and Headliner Finishing Screw
Application:Part #: 153863709
This is a full carpet kit.
Application:Part #: 143971919
Rear Window Defroster Wire Tubes (Pair)
Application:Part #: 111498051AGR
This kit contains the pins, bushings and shims that attach the spindle to the axle beam on king and link pin front ends.
Application:Part #: 111813161
Engine Bay Shelf, Left
Application:Part #: 2501602E
We make wheel adapters for some of the more common drums and wheels.
Application:Part #: 111857233AA
Radio Block Off Plate with chrome strip and clips
Application:Part #: 361141719HD
Clutch Cable Arm Forged for 20mm Cross shaft
Application:Part #: 133711717B
Heater cables open the flaps in the heater boxes allowing heat into the car.
Application:
These locks keep the vent wing closed, therefore a must, but they're a pain to replace.
