Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
The clutch cover is also known as a pressure plate.
The clutch cover is also known as a pressure plate. A lot of people replace the clutch cover when it's not necessary. To check the clutch cover, look at the surface where the disc rides, make sure it's in good condition. Now place the clutch cover on the floor and step on it (bounce on it) to see if it still has tension. Note: When putting the clutch cover on, use a clutch alignment tool in the disc and start the bolts by hand. Use wafer washers under the bolts. Tighten the bolts in a star pattern until the cover sits flat. Torque the bolts to 18 ft. lb., any more and they will break, any less and they will come loose.
No customer reviews for the moment.
Part #: 111141165A
Also known as a throw-out bearing, this bearing's function is to disengage the clutch.
Application:Part #: 1141024
These are hardend bolts, 10.9 instead of the stock 8.8.
Application:Part #: 211141031L
This disc transfers the power from the motor to the transmission.
Application:Part #: 311141025C
The clutch cover is also known as a pressure plate.
Application:Part #: 091141701
This shaft holds the throw-out bearing in place.
Application:Part #: 251721401A
This master cylinder pushes fluid to the slave cylinder on the clutch..
Application:Part #: 111141177AS
These clips hold the throw-out bearing to the arm.
Application:Part #: 1141025CH
HD Pressure Plate 1700 lbs China
Application:Part #: 211703291
Clutch Pedal Return Buffer
Application:Part #: 1141027
Kennedy Stage 3 Pressure plate 2600 LB
Application:Part #: 029141031A
This disc transfers the power from the motor to the transmission.
Application:Part #: 361141719HD
Clutch Cable Arm Forged for 20mm Cross shaft
Application:Part #: 113141701C
This shaft holds the throw-out bearing in place.
Application:Part #: 251721263A
This slave cylinder moves the clutch arm, releasing the clutch.
Application:Part #: 1141028
Kennedy Stage 4, 3000 LB Pressure Plate
Application:Part #: 1198026
This kit contains a quality brass bushing, a clutch return spring and retaining clips needed to install the throw-out bearing arm in the transmission.
Application:
The clutch cover is also known as a pressure plate.
