Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These locks keep the vent wing closed, therefore a must, but they're a pain to replace.
These locks keep the vent wing closed, therefore a must, but they're a pain to replace. Start by removing the glass and rubber. Use a 1/8" drill and drill out the original rivets. Next, remove whatever is left of the old lock and install the new lock. Using 1/8" pop rivets, install the head of the lock from the frame side. With a hammer and dolly, very carefully flatten what's left of the rivet on the latch side. Now replace the glass and rubber.
Bug (Type 1): 65-67
Type 3: 62-67
Race/Off-Road: 65-67
No customer reviews for the moment.
Part #: 171881595A
These are the cables that release the back of the seats.
Application:Part #: 1845111AL
Bug Safari Glass to Frame Seal
Application:Part #: 211857145
Gas Door Rubber Stops
Application:Part #: 113501229D
This joint allows the axle to move up and down and turn on IRS cars.
Application:Part #: 211609701C
Emergency Brake Cable (3330mm/131.1")
Application:Part #: JC22360
Jaycee Fuel Pump Block off w/ 3/8" Breather, Silver
Application:Part #: 025109355
Vanagon Push Rod Tubes (Set of 8)
Application:Part #: 111801041CX
Inner Rocker Panel Left
Application:Part #: 251201075AD
Fuel Tank 70mm Filler with Metal Fill Pipe
Application:Part #: 111953161CL
These are the lenses that go over the front turn signal bulb holders.
Application:Part #: 1109338
These push rod tubes are spring loaded and are great for replacing bent tubes without having to pull the head(s) off.
Application:Part #: 111951111H
This little unit goes beep-beep.
Application:Part #: 111707111
Front Bumper Bar, Bare Steel
Application:Part #: 151871400A
Convertible Top Chrome Molding Kit
Application:Part #: 1256091
J-Tubes, replace stock heater boxes, eliminates heater and saves weight, come with gaskets, sold in pairs
Application:
These locks keep the vent wing closed, therefore a must, but they're a pain to replace.
