Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:Bug Safari Glass to Frame Seal
Bug Safari Glass to Frame Seal
No customer reviews for the moment.
Part #: 1127110ALM
This is stainless steel braided fuel line.
Application:Part #: 113609637
Bracket for Rear Emergency Brake Cable
Application:Part #: 111201621B
Fuel Tank to Body Seal, Fiber
Application:Part #: 211809202
"A" Post Repair Section, Right
Application:Part #: 311401301C
Lower Outer Needle Bearing For Front Beam (2 required)
Application:Part #: 6707301CH
These bumpers are made for Baja Bugs.
Application:Part #: 6857636
Weld on Dash Grab Handle. Raw Finish
Application:Part #: 151871198A
This is the pad between the top material and the headliner.
Application:Part #: n146841
Step stud
Application:Part #: 1601125
These are studs and nuts for different types of wheels.
Application:Part #: 113415821
These are the ball joints on the tie rods.
Application:Part #: 261829565P
This key is what the factory gave you to open the engine door and the gas door on buses up to 1966..
Application:Part #: 113611817
This is the grommet for the reservoir line(s) where they go into the master cylinder. 17.5mmx4.5mm
Application:Part #: 2711100
Gear shift extensions angle back and add about 5" of length to your stock shifter, which allows you to reach the shifter without leaning forward..
Application:Part #: 113863701B
These rubber mats go on the front and rear floors.
Application: