Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:These locks keep the vent wing closed, therefore a must, but they're a pain to replace.
These locks keep the vent wing closed, therefore a must, but they're a pain to replace. Start by removing the glass and rubber. Use a 1/8" drill and drill out the original rivets. Next, remove whatever is left of the old lock and install the new lock. Using 1/8" pop rivets, install the head of the lock from the frame side. With a hammer and dolly, very carefully flatten what's left of the rivet on the latch side. Now replace the glass and rubber.
Bug (Type 1): 68-79
No customer reviews for the moment.
Part #: 113301265E
These rubber mounts hold the transmission in place.
Application:Part #: 111251051H
This is the exhaust silencer.
Application:Part #: 113821021M
These new front fenders are not as thick as the original German fenders.
Application:Part #: 211609632B
E-Brake Push Bar, Right
Application:Part #: 311945191A
This seal goes between the tail light housing and the body of the car..
Application:Part #: VDO360001
These are the most common sending units.
Application:Part #: 311971907
Turn Signal Switch Grommet for Type 1, fuel pump and backup harness grommet on late Type 2, and main harness through body early Type 2
Application:Part #: 211721351
This pin goes on the front end of the clutch cable and should be replaced when you replace the cable.
Application:Part #: 111105259
The bolt and washer that holds the crankshaft pulley on.
Application:Part #: N124241
Foot Pedal Snap Ring holds pedal shaft to Pedals
Application:Part #: T1101026
If you are going to rebuild your own motor it is a good idea to get an engine stand.
Application:Part #: 1127105ALM
This is stainless steel braided fuel line.
Application:Part #: 211499131
Lock Plate, Axle Beam to Body, 8 Required
Application:Part #: 117875575
This is the cover (top) for 57-63 sunroof bugs.
Application:Part #: 211611070BR
This hydraulic slave cylinder is found in the front brake backing plate.
Application:Part #: 113837419
Rear Felt Guide Rail, Each
Application: