Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These locks keep the vent wing closed, therefore a must, but they're a pain to replace.
These locks keep the vent wing closed, therefore a must, but they're a pain to replace. Start by removing the glass and rubber. Use a 1/8" drill and drill out the original rivets. Next, remove whatever is left of the old lock and install the new lock. Using 1/8" pop rivets, install the head of the lock from the frame side. With a hammer and dolly, very carefully flatten what's left of the rivet on the latch side. Now replace the glass and rubber.
Bug (Type 1): left,56-64, Conv.,56-64
Race/Off-Road: left,56-64
No customer reviews for the moment.
Part #: 211615107ACO
Front calipers hold the brake pads that stop the rotor, which in turn stops your vehicle.
Application:Part #: 6415066
Rack and Pinion Unit, 2 mounting holes, 11 5/8", 36 Spline Shaft, 1.5 turns lock to lock
Application:Part #: 151863010
These are the interior panels.
Application:Part #: 6.2010711E+018
Spun aluminum gas tanks for Buggies, come with either end fill or center fill option.
Application:Part #: 113517289A
These are the seals that go around the final drives on an IRS transmission.
Application:Part #: 1941115CB
Headlight lens "Cibie" Style
Application:Part #: N102174
This is a list of the most common bolts used on a car..
Application:Part #: 211837296D
The striker is what keeps the door closed, an absolute necessary part to say the least.
Application:Part #: 211881375
This is the padding that sits on top of the springs of the seat.
Application:Part #: 1101386
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1601130RA
Open end Aluminum Lug Nuts, 12 point, 14mm-1.5, Raw
Application:Part #: 281611349
This cap sits on the top of the brake fluid reservoir filler hole.
Application:Part #: 1141030
200mm 6 puck Clutch Disc
Application:Part #: SRHT6V
A 6volt gear that fits the high torque starter.
Application:Part #: 211703022A
Sections that are used for repairing the frame.
Application:Part #: 111837231
Door Handle/Window Crank Buffers - Inside Anit-rattle buffer
Application:
These locks keep the vent wing closed, therefore a must, but they're a pain to replace.
