Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These connecting rods are longer than stock.
These connecting rods are longer than stock. They should be used on 82mm cranks to give a better rod angle. If you use shorter rods the motor will wear out prematurely.
Bug (Type 1): 1600
Type 3: 1600
Ghia: 1600
Thing: 1600
Race/Off-Road: 1600
No customer reviews for the moment.
Part #: 211953051
Turn signal Bulb Holder, Front Bullet Type Blinker
Application:Part #: 1903109CH
This is a stock generator pulley that has been chromed.
Application:Part #: 2805002WH
This mounts the tire onto the front of the bus getting it out of the interior.
Application:Part #: 1256092
Also called J-tubes, these tubes fit most header systems and replace the stock heater boxes, so you will lose your heat and defroster..
Application:Part #: 113255355B
This is the hose that goes from the body to the engine.
Application:Part #: 113301264
These rubber mounts hold the transmission in place.
Application:Part #: 1601101B
These are studs and nuts for different types of wheels.
Application:Part #: 2847105ASS
New replacement pop out window frames in Stainless Steel
Application:Part #: 1411300AN
Narrowed Sway Bar for Narrowed, Adjustable Front Beam, Link Pin
Application:Part #: 6401233
These go from the front beam to the belly pan to strengthen the front beam area.
Application:Part #: 6801230
These aluminum mounts are made to go around tubing so you can mount your "stuff" in style..
Application:Part #: N90305201
Intake Manifold Sleeve
Application:Part #: 1115458
The smooth flow design has a nice look and comes with a knurled cross-groove or smooth billet grooved cap for a good grip when it is wet or oily.
Application:Part #: 211609237B
These four shoes or linings are in the front drums and are sold on an exchange basis.
Application:Part #: 1109398
These rocker studs are much stronger than the stock studs and are .100" longer to allow more flexibility when setting your rocker arm geometry..
Application:
These connecting rods are longer than stock.
