Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N109052
Screws for replacement pop out window frames. These screws are for joining the two Popout frame halves together
Application:It's possible to put a generator on an alternator stand but not the other way around.
It's possible to put a generator on an alternator stand but not the other way around. This stand holds either a generator or an alternator in place. Note: If you are buying this to change from 6v to 12v don't forget that you will also need to change the strap, pulley and rear generator tin.
Bug (Type 1): 40hp-1600
Bus (Type 2): 40hp-1600
Type 3: 40hp-1600
Ghia: 40hp-1600
Thing: 40hp-1600
Race/Off-Road: 40hp-1600
No customer reviews for the moment.
Part #: N0145051
Some of the most common studs you might need.
Application:Part #: 113105245FRS
Rear Main Seal, Double Lipped
Application:Part #: 1101157
This cam plug is made out of billet alluminum and has an o-ring on it.
Application:Part #: 1101031
Included in this kit are the bolts, nuts and washers required for "out to head" assembly of the engine..
Application:Part #: N122412
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: N105001
These are the bolts that hold the engine in.
Application:Part #: 111198003
This kit contains most of the seals and gaskets necessary to rebuild an engine.
Application:Part #: N104701
These are the bolts that hold the engine in.
Application:Part #: N115244
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 043101129
This is the washer used under the nuts on cases that use an o-ring on the center main studs.
Application:Part #: 1101461KIT
This kit has the correct studs for a dual port engine to hold the heads on. 10mm
Application:Part #: 111199101
These are the bolts that hold the engine in.
Application:Part #: 040101157
This plug goes in the back of the case (flywheel side).
Application:Part #: 111198007AF
This kit contains most of the seals and gaskets necessary to rebuild an engine.
Application:Part #: 1115139
When plumbing the oil filter, oil cooler and/or case, these are the fittings you will need.
Application:Part #: 1101146
These cheater studs replace the head studs that have pulled from the case.
Application: