Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is the seal that goes on the body for the front hood to sit on.
This is the seal that goes on the body for the front hood to sit on. It seals the trunk compartment. Removing the old seal is just a matter of ripping it out. Before you try and put the new seal in, take some time and straighten out the groove it goes in. To put the seal in, start on one side in an upper corner, use some dish soap on the seal and slide it from one side to the other corner then down both sides. On Bugs 1961 on, stick the little nubs in the corner through the holes and use a pair of needle nose pliers to pull the nubs all the way through. On Super Beetles they have pins that hold the seal in the corners. Don't stretch the rubber, as overtime it will shrink.
Bug (Type 1): SB,71-79
No customer reviews for the moment.
Part #: 111945095N
This assembly comes with the bulb holder and lens.
Application:Part #: 1119027CH
This small fan shroud came on the 36hp motor.
Application:Part #: 131415801F
These two rods go from the center pin on a Bus or the pitman arm on a Bug, to the spindles, making the car turn.
Application:Part #: B1090111
Bentley .
Application:Part #: 111837298A
Striker Plate Screw (Long), 3 required
Application:Part #: 211845521
This seal is for the rear window.
Application:Part #: N0111633
Some of the more common nuts you might need..
Application:Part #: 151871031
This is the outer skin on your convertible.
Application:Part #: 113415979
These boots cover the u-joints on your Super Beetle.
Application:Part #: 211501293A
This nut goes on the inner side of the lower axle shaft of your large nut (46mm) recution boxes.
Application:Part #: 1821305C
These were originally sold as an accessory by the dealer.
Application:Part #: 1411300AN
Narrowed Sway Bar for Narrowed, Adjustable Front Beam, Link Pin
Application:Part #: 211801393
This is the most common place for rust on your bus.
Application:Part #: 1117024FAN
This is the same as the mesa cooler but with a fan mounted to it.
Application:Part #: 111881373
This is the padding that sits on top of the springs of the seat.
Application:
This is the seal that goes on the body for the front hood to sit on.
