Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
We like to run EMPI deluxe headers because they have the best fit, as well as, a good merge on the collector.
We like to run EMPI deluxe headers because they have the best fit, as well as, a good merge on the collector. The collector is the most important part of a header. We suggest using a single quiet muffler on engines that have a stock carburetor or two, one-barrel carbs. You should run dual mufflers or one giant muffler on engines that have two, two-barrel carbs. If you're using the stock intake manifold, you'll need to drill out the heat riser stands on the header.
Bus (Type 2): 72-74,79-84
No customer reviews for the moment.
Part #: 1251261
Paper gaskets are not our favorite, but if you are running larger ports, you have to use them.
Application:Part #: 113251265
This kit includes the gaskets and hardware to install a stock muffler or tail pipes..
Application:Part #: 1251201CH
Chrome Heat Riser Block-Off Plate Kit
Application:Part #: 1251200
This kit comes with four flanges, two for the heater boxes and two for the header. Sold EACH, 2 required.
Application:Part #: 2251006
We like to run EMPI deluxe headers because they have the best fit, as well as, a good merge on the collector..
Application:Part #: 1251210
These are two of the different types of exhaust nuts.
Application:Part #: 1251202FL
This is the 3-bolt gasket that goes between the muffler and the header.
Application:Part #: 1256091
J-Tubes, replace stock heater boxes, eliminates heater and saves weight, come with gaskets, sold in pairs
Application:Part #: 1251211
These are two of the different types of exhaust nuts.
Application:Part #: 2251010
Header Only, 1 1/2" tubing
Application:Part #: 1251261C
Paper gaskets are not our favorite, but if you are running larger ports, you have to use them.
Application:Part #: 1251211S
HD Racing Exhaust Nuts, 8mm-1.25 thread, 11mm head (Set of 8)
Application:Part #: 125121112
Exhaust nuts 12 Point 8mm-1.25, use 10mm 12 point socket (8 per kit)
Application:Part #: 2251008
We like to run EMPI deluxe headers because they have the best fit, as well as, a good merge on the collector.
Application:Part #: 2251005
We like to run EMPI deluxe headers because they have the best fit, as well as, a good merge on the collector.
Application:Part #: 111251261B
This kit includes the gaskets and hardware to install a stock muffler or tail pipes..
Application:
We like to run EMPI deluxe headers because they have the best fit, as well as, a good merge on the collector.
