Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These rings are cast iron.
These rings are cast iron. We prefer them over the chrome rings that come in the above big bore kits. It's true that with chrome rings your barrels won't wear as much, but that's because they never seat. We suggest you take the rings off the piston and give them to your girlfriend for bracelets. They're a cheap gift and she won't be around much longer anyway if you don't stop spending so much time on your motor. Be careful putting the rings on, as they can break. Always use spreader pliers. They are sold in sets.
Bug (Type 1): All
Type 3: All
Ghia: All
Thing: All
Race/Off-Road: All
No customer reviews for the moment.
Part #: 1101441
This is a shim that is used between the head and barrel.
Application:Part #: 1101346
36 HP Barrel Shims .060 (4)
Application:Part #: N122412
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 043101457
These nuts and washers hold the heads on.
Application:Part #: 113101355ACO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 113101353ERB
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld). Due to a shortage of cores we will need your Cylinder head Cores before sending any Rebuilt heads.
Application:Part #: 1198090B
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 1101394
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 021101457
These nuts and washers hold the heads on.
Application:Part #: 1198161TS
90.5mm Piston Rings 1.5x2x4 Total Seal
Application:Part #: 111198057A
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
Application:Part #: 113101401
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1101342
36 HP Barrel Shims .020 (4)
Application:Part #: 1101448
This is a shim that is used between the head and barrel.
Application:Part #: 1198163ATS
94mm Piston Rings Total Seal
Application:Part #: 1198163A
These rings are cast iron.
Application:
These rings are cast iron.
