Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is the seal that goes on the body for the front hood to sit on.
This is the seal that goes on the body for the front hood to sit on. It seals the trunk compartment. Removing the old seal is just a matter of ripping it out. Before you try and put the new seal in, take some time and straighten out the groove it goes in. To put the seal in, start on one side in an upper corner, use some dish soap on the seal and slide it from one side to the other corner then down both sides. On Bugs 1961 on, stick the little nubs in the corner through the holes and use a pair of needle nose pliers to pull the nubs all the way through. On Super Beetles they have pins that hold the seal in the corners. Don't stretch the rubber, as overtime it will shrink.
Bug (Type 1): 61-77, SB,71-72
Offroad/Race: 61-77
No customer reviews for the moment.
Part #: 111955407D
The arms extend from the shaft to hold the wiper blades, very rarely do they fail..
Application:Part #: 211201125D
Fuel Tank Filler Hose, Curved
Application:Part #: 2129701
We've found that dual carbs work better than any single carburator set up.
Application:Part #: 211611070C
This hydraulic slave cylinder is found in the front brake backing plate.
Application:Part #: APWG510
Standard issue uniform around here. These look the same as the Men's, but are a smaller/tighter fit for a Women's body
Application:Part #: JC22390
Jaycee Fuel Pump Block off w/ AN 8 Fitting, Blue
Application:Part #: 1511221
Torsion Tube End Plates, Inner, Pair
Application:Part #: 113127521AWG
This metal line goes from the pump around the fan shroud to the flex line that comes from the gas tank.
Application:Part #: 211703501B
Emergency Brake Cable Tube 1535mm
Application:Part #: 151867503
This is the vinyl covering for the inside roof and sides of the Bug.
Application:Part #: 1251261C
Paper gaskets are not our favorite, but if you are running larger ports, you have to use them.
Application:Part #: 1109403
These shims are used with the Solid Shaft Rocker Kit.
Application:Part #: 211947107AWW
Dome Light Bulb Holder
Application:Part #: 211945363A
This is the lens that you see on the side of the bus in the front and the rear.
Application:Part #: 113863700
These rubber mats go on the front and rear floors.
Application:Part #: 1615107F
Replacement Front Brake Bracket for Kit # 1615100F, Pair
Application:
This is the seal that goes on the body for the front hood to sit on.