Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This disc transfers the power from the motor to the transmission.
This disc transfers the power from the motor to the transmission. To check an old clutch disc, use a 7mm wrench and try to put the open end over the thickness of the disc. If the wrench goes on, you should think about replacing the disc. There are basically two types of discs, ridged and one with springs. The spring type has a little give before it engages, reducing the shock on the transmission. The ridged discs are good for dirt cars or someone who wants to race at the drag strip.
No customer reviews for the moment.
Part #: 113141701C
This shaft holds the throw-out bearing in place.
Application:Part #: 111721305C
This is the shaft that the clutch pedal attaches to.
Application:Part #: 111141177AS
These clips hold the throw-out bearing to the arm.
Application:Part #: N122412
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 111141165A
Also known as a throw-out bearing, this bearing's function is to disengage the clutch.
Application:Part #: 111141723A
Return Spring For Cross Shaft
Application:Part #: 111141719HD
Clutch Cable Arm Forged for 20mm Cross shaft
Application:Part #: 131141719HDL
Clutch Cable Arm Forged for 16mm Cross shaft
Application:Part #: 1198026A
This kit contains a quality urethane bushing, a clutch return spring and retaining clips needed to install the throw-out bearing arm in the transmission.
Application:Part #: 1141024
These are hardend bolts, 10.9 instead of the stock 8.8.
Application:Part #: 113198026
This kit contains a bushing, a clutch return spring and the retaining clips to install the throw-out bearing shaft in the transmission.
Application:Part #: 1141031
These clutch disc do not slip.
Application:Part #: 361141719HD
Clutch Cable Arm Forged for 20mm Cross shaft
Application:Part #: 113721305B
This is the shaft that the clutch pedal attaches to.
Application:Part #: 1141028
Kennedy Stage 4, 3000 LB Pressure Plate
Application:Part #: 211141025A
Clutch Cover, 12 volt 200mm, 9 spring
Application:
This disc transfers the power from the motor to the transmission.
