Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This hydraulic cylinder feeds all the wheel cylinders.
This hydraulic cylinder feeds all the wheel cylinders. After installing a new one make sure the rod that pushes the plunger is adjusted correctly. When adjusting it you can't see the measurement but you can feel it. The rod should have about an 1/8" of free play before it starts pushing. If it's too tight it will not allow the fluid to travel back to the reservoir locking up the brakes usually in the middle of an intersection.
Bus (Type 2): 71-79
No customer reviews for the moment.
Part #: 281611349
This cap sits on the top of the brake fluid reservoir filler hole.
Application:Part #: 211611313J
The reservoir holds the brake fluid for the brake master cylinder.
Application:Part #: 211611313G
This reservoir is for a 68-72 Bus. The reservoir holds the brake fluid for the brake master cylinder.
Application:Part #: 211611309
Brake Fluid Reservoir, includes cap
Application:Part #: 211611309B
Brake Fluid Fill Reservoir
Application:Part #: 211611313K
Brake Fluid Reservoir for Servo Assisted Braking system 85mm/3.34" hole spacing
Application:Part #: 211611833C
Brake Line Grommet (2 per bus)
Application:Part #: 211611905
Brake Servo
Application:Part #: 251611301K
Dual Circuit Brake Fluid Reservoir
Application:Part #: 211813356A
Rear Corner to Beltline, Right
Application:Part #: 1857207BK
These panels go in the dash so you can install gauges.
Application:Part #: 1903183
This aftermarket chrome cap nut and spacer hold the alternator/generator pulley on.
Application:Part #: 1115351BUL
This is the last oil filter you will ever buy.
Application:Part #: JC86190
Jaycee Billet 4.5" Crank Pulley for Drag Cars, Silver
Application:Part #: 021256205K
These control boxes on 72-79 Buses and 75-79 Super Beetles, let the heat into the car.
Application:Part #: 251612501
Brake pressure regulator
Application:Part #: N0201121
These nuts hold the wheel on.
Application:Part #: 113837606A
Vent Window Assembly, Right
Application:Part #: 111945355
When you apply the brakes, the brake light switch activates the brake lights.
Application:Part #: 111837639BHD
These locks keep the vent wing closed, therefore a must, but they're a pain to replace.
Application:Part #: 1198092A
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 211809101X
Rocker Panel, Left, Lower, Outer, 8"
Application:Part #: 113117021
This stock oil cooler cools the hot oil coming from the engine.
Application:Part #: 1115457
The smooth flow design has a nice look and comes with a knurled cross-groove or smooth billet grooved cap for a good grip when it is wet or oily.
Application:Part #: 1401021CL
This is a brand new axle beam with adjusters already installed.
Application:
This hydraulic cylinder feeds all the wheel cylinders.