Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N141212
These are the latches that hold the popout frame out.
Application:This is the same as the mesa cooler but with a fan mounted to it.
This is the same as the mesa cooler but with a fan mounted to it. You can get this in a 72 plate cooler or a 96 plate cooler. Keep in mind, due to the fan, you will need a little more space when mounting. Make sure you leave an air gap between the cooler and any flat surface. See FAN THERMOSTATS for automatic switching of the fan.
Bug (Type 1): All
Bus (Type 2): All
Type 3: All
Ghia: All
Thing: All
Race/Off-Road: All
No customer reviews for the moment.
Part #: 1117012
These bolt on mounts allow you to bolt the filter adapter under the driver's side fender or hang it off the exhaust flange..
Application:Part #: JC21020
Jaycee Mag-Plate, 6 Bolt, Black
Application:Part #: 1117104ALM
These fittings are used for the stainless steel hose.
Application:Part #: 311115541
This boot goes on the end of the dump tube.
Application:Part #: 113115181A
This is the plate on the bottom of the motor.
Application:Part #: 1115610BK
Billet Dipstick, Black
Application:Part #: JC22250
Jaycee Billet Oil Cap with Breater -10 AN Fitting, Red
Application:Part #: 113115175
This screen fits in the sump around the pick up tube.
Application:Part #: 1115455
The smooth flow design has a nice look and comes with a knurled cross-groove or smooth billet grooved cap for a good grip when it is wet or oily.
Application:Part #: 1117109
This block off plate is made to loop the oil back into the case in place of the stock oil cooler.
Application:Part #: 1115457BL
The smooth flow design has a nice look and comes with a knurled cross-groove or smooth billet grooved cap for a good grip when it is wet or oily. Blue
Application:Part #: 6115349
If you built your motor out of a type 3 case, you probably notice that once you got it all together you're missing a dipstick tube.
Application:Part #: 111115161
These nuts prevent oil from leaking around the oil pump studs.
Application:Part #: JC22960
Jaycee Billet Full Flow Pump Cover w/ -8 O-ring Fitting, Blue
Application:Part #: 1115141BL
This oil pump cover comes with a threaded boss.
Application:Part #: 111115495
This is more of a bolt than a nut.
Application: