Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
The rear wheel attaches to the rear brake drum.
The rear wheel attaches to the rear brake drum. Make sure you torque the axle nut to 250 ft. lb., we don't want any wheels falling off. We suggest you drive the Bug for a day and tighten the nut again. For some reason the nut seems to loosen up the first time. Always use a cotter pin to lock the nut. If the hole doesn't line up, tighten it a little bit more until it does. Never, ever back the nut off to line up the hole.
No customer reviews for the moment.
Part #: 211609209
These are the screws and adjusting stars that freeze up and keep you from adjusting your brakes.
Application:Part #: 113609205A
These are the screws and adjusting stars that freeze up and keep you from adjusting your brakes.
Application:Part #: 131609209
These are the screws and adjusting stars that freeze up and keep you from adjusting your brakes.
Application:Part #: 211611483
This valve in the wheel cylinder allows you to bleed the brakes.
Application:Part #: 113698273
This kit is for rebuilding the wheel cylinder.
Application:Part #: 113698261A
This kit is for rebuilding the wheel cylinder.
Application:Part #: 113611055C
This hydraulic slave cylinder is found in the rear brake backing plate.
Application:Part #: 131611055GR
This hydraulic slave cylinder is found in the rear brake backing plate.
Application:Part #: 111698003
This kit has all the springs, pins and keepers for drum brakes.
Application:Part #: 113698003
This kit has all the springs, pins and keepers for drum brakes.
Application:Part #: 131609537C
These shoes or linings are in the rear drums and are new, so no exchange.
Application:Part #: 113609537B
These shoes or linings are in the rear drums and are new, so no exchange.
Application:Part #: 131611055
Rear Wheel Cylinder
Application:Part #: N114805
Screw for One Eyed Duck
Application:Part #: 111945185
Taillight/Turn Signal Screw
Application:Part #: 111821715A
This is the beading that goes between the fender and the body.
Application:Part #: 1101399
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 021115411a
Oil Pressure Relief Piston
Application:Part #: 311945223C
These are the rear lenses for the tail light, brake light and turn signal light.
Application:Part #: 1911021
This relay fits next to the starter and shortens the travel of amperage needed to engage the starter.
Application:Part #: 311501325
Axle Bearing Cap Bolt (Set of 4)
Application:Part #: 021101269A
Oil Sump Lid O-Ring
Application:Part #: 111827301
Engine Deck Lid Hinge
Application:Part #: 133711717
Heater cables open the flaps in the heater boxes allowing heat into the car.
Application:Part #: 211813242
These are the panels on the side of the engine that holds the seal for the engine.
Application:Part #: 1070276K
Stainless Steel Bug (Type 1) Roof Rack (Knockdown Style)
Application:Part #: 1105279
This gasket is only used if you're having problems with your end play.
Application:Part #: 411881331C
Seat Side Cover Screw and Washer Cover (8 Required)
Application:Part #: 117867506
This is the vinyl covering for the inside roof and sides of the Bug.
Application:
The rear wheel attaches to the rear brake drum.
