Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This box is made so you can weld it to a piece of 1 1/2" tubing and mount it to your shifter.
This box is made so you can weld it to a piece of 1 1/2" tubing and mount it to your shifter. You'll also need a bushing. Note: You can use the stock bushing 111 701 259A or the better bolt in bushing. Try to keep your box as "in-line" with the transmission as possible.
Race/Off-Road: All
No customer reviews for the moment.
Part #: 211955225C
Safari wiper pivots
Application:Part #: 1129709
This pair of aluminum end castings are for use with a center section manifold.
Application:Part #: 211801562Z
Rear Wheel Well Front Repair Section, Right
Application:Part #: 111721231A
Brake Pedal Stop Plate
Application:Part #: 1903109POL
Polished Billet Alternator/Generator Pulley Kit
Application:Part #: 211805265B
Headlight Bucket
Application:Part #: 1105254BK
This is a crank pulley for an upright motor.
Application:Part #: VDO600840
VDO Gauge Insulated Bulb Socket, Peanut Style
Application:Part #: 113251265
This kit includes the gaskets and hardware to install a stock muffler or tail pipes..
Application:Part #: 1501611
We make wheel adapters for some of the more common drums and wheels.
Application:Part #: 1711105
The aftermarket shifters listed here, shorten the shift pattern considerably.
Application:Part #: 2711101PL
Gear shift extensions angle back and add about 5" of length to your stock shifter, which allows you to reach the shifter without leaning forward..
Application:Part #: 111953161C
These are the lenses that go over the front turn signal bulb holders.
Application:Part #: N185163
Screws-- 4mmx10mm Counter sink
Application:Part #: 111698131
This kit contains the replacement spring clips and rivets to hold hub caps on.
Application:Part #: 01006
These are the parts found in the distributor.
Application:
This box is made so you can weld it to a piece of 1 1/2" tubing and mount it to your shifter.
