Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This cable pulls the arm that releases the clutch.
This cable pulls the arm that releases the clutch. When replacing the cable, it will last longer and work better if you use white grease on it and on the clevis pin or hook. The easiest way to replace a cable is to remove the nut(s) from the clutch arm at the trans. Pull the bowden tube out of the bracket so it is straight. Pull the cable out from the front and replace it in the reverse order. On 68-71 Buses a two bolt bell where the clutch pedal shaft is bolted to the frame will need to be removed to get to the clevis pin. It is good idea to replace the clevis pin at this time on buses. We recomend having a spare in the car, in case it breaks while out in the middle of nowhere.
Bug (Type 1): 72-74
Ghia: 72-74
Thing: 73-74
Race/Off-Road: 72-74
No customer reviews for the moment.
Part #: 111721365
The clutch cable boot goes over the end of the bowden tube where the cable moves in and out.
Application:Part #: 131721349
This adjustment nut goes on the end of the cable, back by the transmission.
Application:Part #: 113701293C
This boot goes in the pan to encase the throttle and clutch tubes that come out of the pan.
Application:Part #: 211721361D
This tube goes from the metal tube coming out of the tunnel to the bracket on the transmission.
Application:Part #: 111721361E
This tube goes from the metal tube coming out of the tunnel to the bracket on the transmission.
Application:Part #: 261898004
Single Cab Ignition 2 locking front door handles and 2 keys
Application:Part #: 211611011JBR
This hydraulic cylinder feeds all the wheel cylinders.
Application:Part #: 311109335
These tubes go from the case to the heads to house the push rods.
Application:Part #: 211615108
Front calipers hold the brake pads that stop the rotor, which in turn stops your vehicle.
Application:Part #: 211845104B
These are cut from safety glass as required by law. This glass is the factory thickness. Sold each
Application:Part #: 211251053J
This is the exhaust silencer.
Application:Part #: 01052
These are the parts found in the distributor.
Application:Part #: 113867503
This is the vinyl covering for the inside roof and sides of the Bug.
Application:Part #: 113837606A
Vent Window Assembly, Right
Application:Part #: 265809041B
Side Panel, Crew Cab Only, Left
Application:Part #: 071101061D
New complete head Square port
Application:Part #: 113711141GY
This is the knob on top of the shifter..
Application:Part #: 113857637AWH
This cover hides the screws on the assist straps.
Application:Part #: N203761
Tank Breather Hose 10mm ID, per foot
Application:Part #: 251829331B
This strut is what holds up the rear hatch of you Vanagon.
Application:
This cable pulls the arm that releases the clutch.
