Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This style of adjusting screw has a ball with a flat side on the end.
This style of adjusting screw has a ball with a flat side on the end. It's the flat side that hits the valve. They're a must if you are using stainless steel valves. Some clearancing of the rocker is necessary to run these screws and the valve geometry is very important. When you get them set up correctly, they're the trick way to go. The screws are 8mm. Please read the article on valve geometry under news and tips on this site.
No customer reviews for the moment.
Part #: 113109641B
These springs return the valves back to their seats.
Application:Part #: 1109613
Stainless steel valves are used in the big valve heads.
Application:Part #: 1109010
Engle cams are one of the most popular performance camshafts made for the air-cooled Volkswagen.
Application:Part #: 043109611A
The two outside valves in the head are the exhaust valves, they let the burned fuel out of the head.
Application:Part #: 1109401125
Rocker Arms, High Ratio 1.25, w/Bushing, Set
Application:Part #: 1109002
Premium Performance Aftermarket Cam Gear
Application:Part #: 111109601A
Intake Valve 30mm (each)
Application:Part #: 113109612A
The two outside valves in the head are the exhaust valves, they let the burned fuel out of the head.
Application:Part #: 113109301D
These rods link the cam to the valves. These are very costly so please call for good used ones.
Application:Part #: 1109651
We have had good luck with stock keepers on single springs.
Application:Part #: 113101399B
Rocker Arm Stud
Application:Part #: 1109461
These shims are used under the rockers to set the geometry.
Application:Part #: 1109603
Stainless steel valves are used in the big valve heads.
Application:Part #: 113109335
These tubes go from the case to the heads to house the push rods.
Application:Part #: 1109009
We have had good luck with this cam and prefer it over new stock cams and is a great cam when you want to stay with the stock carburetor or Kadrons.
Application:Part #: 1109398
These rocker studs are much stronger than the stock studs and are .100" longer to allow more flexibility when setting your rocker arm geometry..
Application:
This style of adjusting screw has a ball with a flat side on the end.
