Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This tin goes from one piece of cylinder tin to the other.
This tin goes from one piece of cylinder tin to the other. It mates up with the tin that is behind the crank pulley. They make two styles of crank pulley tin, so it's very important that you use the early, short style tin with one of these. The fit is poor.
Bug (Type 1): 40hp-1600
Bus (Type 2): 40hp-1600
Ghia: 40hp-1600
Thing: 40hp-1600
No customer reviews for the moment.
Part #: N115244
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 1119526BK
This tin goes from one piece of cylinder tin to the other.
Application:Part #: 1119516CH
This piece of tin goes behid the engine towards the flywheel and screws down to the cylinder tins.
Application:Part #: 311119317A
These are also known as the "forget-me-nots".
Application:Part #: 131119358
These are the short pieces that fit under the big cylinder tin towards the crank pulley.
Application:Part #: 1119028CH
This small fan shroud came on the 36hp motor.
Application:Part #: 1119527CH
This tin goes from one piece of cylinder tin to the other.
Application:Part #: 1119317BK
Cool tins are must for those of you with high performance exhaust systems without heater boxes.
Application:Part #: 1119026CH
This style fan shroud combines the small shroud of the 36hp and the later doghouse style shroud.
Application:Part #: 111119571
In the stock front pulley tin, there is a hole for the 1" hose coming down from the stock air cleaner.
Application:Part #: 1119023
This spacer kit uses 1 1/4" thick aluminum spacers to close the gap between the fan shroud and the cylinder tins where the sheet metal screw attaches.
Application:Part #: 1119528BK
This tin goes from one piece of cylinder tin to the other.
Application:Part #: 1903032CH
These are the three pieces of tin that go on the back of the generator or alternator.
Application:Part #: 1119303BK
These cylinder head tins sit under the fan shroud.
Application:Part #: 1903031CH
This is one of the three-pieces of the Alternator or Generator Tin Set, it's the large flat plate that is seen.
Application:Part #: 1119525BK
This tin goes from one piece of cylinder tin to the other.
Application:
This tin goes from one piece of cylinder tin to the other.
