Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:Seat Belt, 3 Point Retractable with hardware, Right
Seat Belt, 3 Point Retractable with hardware, Right
Bug (Type 1): 1967-77 Convertible 1967-72
Offroad: 1967-77
No customer reviews for the moment.
Part #: 221841647
Spring for Inside Cargo door Handle
Application:Part #: 311837247BK
This is the trim piece that goes around the inside front door handle.
Application:Part #: 111115495
This is more of a bolt than a nut.
Application:Part #: 113127311
These stock pumps pump fuel into the carburetor.
Application:Part #: 211837225ABG
These handles go on the inside of the front doors to open them.
Application:Part #: 1115485CH
A stock cap that has been chromed for looks..
Application:Part #: 151871049C
This is what you see whey you look up at the header bow.
Application:Part #: 111837143
Foam Seal, Door Mech to Door Edge
Application:Part #: 113101353ERB
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld). Due to a shortage of cores we will need your Cylinder head Cores before sending any Rebuilt heads.
Application:Part #: 251405645B
These bearings go in the drum or rotor hub to allow them to spin.
Application:Part #: 131498441
Shock Mounting Kit, Front, Ball Joint, each
Application:Part #: 113105277
These pins hold the flywheel in place on the crankshaft.
Application:Part #: 111698471
This kit comes with the o-rings and dust seals to repair your calipers.
Application:Part #: 151867505
This is the vinyl covering for the inside roof and sides of the Bug.
Application:Part #: 151871359C
These strips screw to the top.
Application:Part #: 133419951
This is the shaft that connects the steering shaft to the steering box.
Application: