Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
If you're rebuilding your own heads, you will probably need guides.
If you're rebuilding your own heads, you will probably need guides. Oversize guides refer to the outer diameter. Note: When installing, heat the head and freeze the guide; they will go in easier. We advise you not to try this yourself unless you have experience in replacing guides.
No customer reviews for the moment.
Part #: 111198157BBB
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: 1198092B
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 315198163A
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: 1198163A
These rings are cast iron.
Application:Part #: 11310140102
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1101481
These are great valve covers gaskets.
Application:Part #: 1109512
Valve seats are used in the big valve heads.
Application:Part #: 11310140105
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 311198169A
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: 113101481F
This gasket goes between the valve cover and the head.
Application:Part #: 113101353BRB
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld). Due to a shortage of cores we will need your Cylinder head Cores before sending any Rebuilt heads.
Application:Part #: 1101448
This is a shim that is used between the head and barrel.
Application:Part #: 311198069FM
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers. MAHLE
Application:Part #: 1101354
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 311101353A
New single port head.
Application:Part #: 1198090BCH
90.5mm Pistons & Cylinders - 82mm Stroke CHINA
Application:
If you're rebuilding your own heads, you will probably need guides.
