Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N141212
These are the latches that hold the popout frame out.
Application:This rubber hose goes from the air cleaner to the carburetor.
This rubber hose goes from the air cleaner to the carburetor. If yours has a hole or rip in it, make sure you replace it or you will be sucking dirt.
No customer reviews for the moment.
Part #: 1129604
This air cleaner takes the place of a stock air cleaner.
Application:Part #: 111198555
This kit allows you to rebuild your square top or 40hp fuel pump.
Application:Part #: 111127141
Fuel Pump Diaphragm 25-36 HP
Application:Part #: 111127591
Fuel Line Grommet 6mm
Application:Part #: 1129600
This is a replacement air cleaner for the Weber IDF.
Application:Part #: 2129702
We have found this kit to be a good, cheap dual carb kit for a stock motor.
Application:Part #: 1129601EL6
This is a replacement air cleaner for the Weber IDF.
Application:Part #: 1129729BKKIT
Dual Port Installation Kit utilizing Black Urethane Boots
Application:Part #: 113129729BS
These boots connect the intake manifold with the end casting on a stock dual port 1600cc engine. Two are required boots are sold individually.
Application:Part #: 1129718
These gaskets are for upright dual port engines.
Application:Part #: 021129637F
We usally find these fittings all taped or glued up.
Application:Part #: 111127511A
This metal line goes from the pump around the fan shroud to the flex line that comes from the gas tank.
Application:Part #: 1129708
This pair of aluminum end castings are for use with a center section manifold.
Application:Part #: 111127591A
Fuel Line Grommet 8mm
Application:Part #: 113129701K
Single Port, Intake Manifold, 1500-1600cc, 30mm Base
Application:Part #: 1129601
This is a replacement air cleaner for the Weber IDF.
Application: