Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This cable pulls the arm that releases the clutch.
This cable pulls the arm that releases the clutch. When replacing the cable, it will last longer and work better if you use white grease on it and on the clevis pin or hook. The easiest way to replace a cable is to remove the nut(s) from the clutch arm at the trans. Pull the bowden tube out of the bracket so it is straight. Pull the cable out from the front and replace it in the reverse order. It is good idea to replace the clevis pin at this time on buses. We recomend having a spare in the car, in case it breaks while out in the middle of nowhere.
Bus (Type 2): 72-79
No customer reviews for the moment.
Part #: 311971907
Turn Signal Switch Grommet for Type 1, fuel pump and backup harness grommet on late Type 2, and main harness through body early Type 2
Application:Part #: 1109602
Valve seats are used in the big valve heads.
Application:Part #: 211941511D
This switch turns on the headlights, as well as, dims the dash lights.
Application:Part #: 111109335
These tubes go from the case to the heads to house the push rods.
Application:Part #: 151871033
This is the outer skin on your convertible.
Application:Part #: 2101000
This is for converting a non hanger case to accept a hanger.
Application:Part #: 111837022B
Door Lock Remote, Right
Application:Part #: 021101361K
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 113853505G
This is the front strip that goes down the front hood.
Application:Part #: 6881399BVTF
These are the real deal.
Application:Part #: 143863704
This is a full carpet kit.
Application:Part #: 1601060APL
Empi 5-Rib 5x205, 5.5"x15"
Application:Part #: 113823579ABK
These seals go underneath the front hood handle.
Application:Part #: 021101403A
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 111881364
This is the padding that sits on top of the springs of the seat.
Application:Part #: 211501221A
A very important nut to say the least.
Application:
This cable pulls the arm that releases the clutch.
